2787-2346 (/0000-00x0)
Configuration
Product manual | Version: 1.0.1
53
Power Supply Pro 2
Area
Settings Option
Description
[View]
Opens a dialog.
You can select the individual operation panels to be
displayed in the dialog.
Operation Panel
Setting Options
Arranges the selected operation panel depending on
the settings in the dialog.
Hides the selected operation panel and anchors the
operation panel as a tab on the outer edge of the dia-
log.
Closes the selected operation panel.
“Control panel Pro 2”
Operation Panel
Optical
Status Indicator
Displays the connected local [unit: %]. You can set the
percentage by clicking the
[slider control]
button in
the “Control panel” operation panel.
[Buttons]
You can set the output voltage.
[+]
: Increases the output voltage
[−]
: Decreases the output voltage
You can enable the function by clicking the
[Power
supply on/off]
button in the “Control panel” operation
panel.
“Control panel”
Operation Panel
The operation panel has two different views:
•
“Load” view:
This view is displayed if the “Load” setting has been enabled in the
Selection
of the signal source
operation panel.
•
“Import load curve” view:
This view appears if the “Import load curve“ setting has been enabled in the
Se-
lection of the signal source
operation panel.
The different views are locked against each other and can only be selected individ-
ually. Individual setting options are also available in both views. These setting op-
tions are described in advance.
[Power Supply
on/off]
Switches the power supply on or off.
[Digital Input
on/off]
Sets the digital input to “1” or resets the digital input to
“0”.
[Slider Control]
Sets the load percentage.
Ambient temperature
You can enter the surrounding air temperature. This
function can be used to illustrate how the temperature-
dependent load derating of works.
Example:
The yellow and red areas in the load display
shift to the left if an surrounding air temperature in the
range +55… +70 ° C is entered. In this way, the tem-
perature-dependent derating is shown visually in the
load display according to the surrounding air tempera-
ture.
“Load” View
Selection of the signal
source: Load
If the checkbox is selected, you can set the load per-
centage by clicking the
[slider control]
button.
The following specific settings options are available:
