34 Mounting
WAGO-I/O-SYSTEM 750 XTR
750-630/040-001 SSI Interface Adjust XTR
Manual
Version 1.1.0
Pos: 25.7 /All e Seri en ( Allgemei ne Module)/Ü berschriften/Ebene 2/Geräte einfüg en und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.docx @ 25950 @ 2 @ 1
5.2
Inserting and Removing Devices
Pos: 25.8 /All e Seri en ( Allgemei ne Module)/Sicherheits- und sonstige Hi nweise/Vorsicht/Vorsicht: H eiß e Oberfläche nicht ber ühr en! (allgemein) @ 6\mod_1264428115588_21.docx @ 48610 @ @ 1
Do not touch hot surfaces!
The surface of the housing can become hot during operation. If the device was
operated at high ambient temperatures, allow it to cool off before touching it.
Pos: 25.9 /All e Seri en ( Allgemei ne Module)/Sicherheits- und sonstige Hi nweise/Gefahr/Gefahr: Nicht an Ger äten unter Spannung arbeiten! @ 6\mod_1256193963573_21.docx @ 43426 @ @ 1
Do not work when devices are energized!
High voltage can cause electric shock or burns.
Switch off all power to the device prior to performing any installation, repair or
maintenance work.
Pos: 25.10 /Serie 750 ( WAGO-I/O-SYST EM)/Wichtig e Erl äuter ung en (alte Struktur)/Sicher heits- und sonstige Hi nweise/Achtung/Achtung: XTR nicht unter -
20 °C verdrahten oder umstecken @ 15
\mod_1367559895186_21.docx @ 118480 @ @ 1
Temperature range applies to normal operation!
XTR I/O modules may be operated below
−20 °C, but not wired and/or
reconnected.
Pos: 25.11 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul ei nfüg en @ 28\mod_1486551092321_21.docx @ 405487 @ 3 @ 1
5.2.1
Inserting the I/O Module
1.
Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.
Figure 7: Insert I/O Module (Example)
