WAGO-I/O-SYSTEM 750 XTR
Commissioning 57
750-652/040-000 Serial Interface RS-232/RS-485 XTR
Manual
Version 1.3.0
8.1.4
Parameter Range
Figure 20: Parameter range
The following selection boxes are displayed in tabular form. The possible settings
are described in more detail in the chapter “Function Description”.
Table 31: Parameter Range
Selection box
Possible settings
Operating Mode
RS-232 / RS-485 half-duplex
*)
/
RS-422 full-duplex / data exchange RS-422 /
DMX half-duplex/250k
Transmission Rate [Baud]
300 / 600 / 1200 / 2400 / 4800 / 9600
*)
/ 19200 /
38400 / 57600 / 115200
Data Bits
8
*)
/ 7
Parity
none
*)
/ odd / even
Stop Bits
1
*)
/ 2
Flow Control
disabled
*
/ XON/XOFF
1)
/ RTS/CTS
2)
/ RTS, lead
and follow-on time
Continuous Send Mode
disabled
*
/ released
Continuous Receive Mode
disabled
*
/ released
Switchover Time RS-485
3)
100 µs
*)
/ 2 Characters / 4 Characters
Continuous Receive Timeout 2 Characters
*)
/ 4 Characters
RTS Pre-Delay [ms]
2)
30
*)
/ [0 … 1000]
RTS Post-Delay [ms]
2)
30
*)
/ [0 … 1000]
DMX - Start Channel Number
4), 5)
1
*)
… 492
* )
default setting
1)
the setting is relevant for the operating mode RS-232/RS-422, full-duplex
2)
the setting is relevant for the operating mode RS-232
3)
the setting is relevant for the operating mode RS-485, half-duplex
4)
the setting is relevant for the operating mode DMX.
5)
from firmware version 06
