WAGO-I/O-SYSTEM 750
Configuration and Parameterization 69
750-658 CAN Gateway
Manual
Version 1.2.1, valid from FW/HW-Version 01/01
9.2
Configuration and Parameterization with
e!COCKPIT
Configuration and parameterization differ only slightly in in
e!COCKPIT
and
WAGO-I/O-
CHECK
. For that reason, only the deviations are explained that apply
to the
e!COCKPIT
software.
Configuration and Parameterization in the
e!COCKPIT
Software!
General information on configuration and parameterization in the
e!COCKPIT
software is available in the respective manual! This manual has item No. 2759-
0101 and can be downloaded at www.wago.com!
There are the following deviations:
•
General:
The “Load” and “Save” functions are automated in the application. Some
files cannot be manually loaded or saved. Therefore, the
[Open]
and
[Save]
buttons are not available in the application menu.
•
Initial start of the application:
When initially starting the application from
e!COCKPIT
, all parameters are
read from the I/O module automatically. Once you exit the application, the
parameters are automatically saved as “Offline parameters”.
•
Starting the application:
When starting the application again, the existing offline parameters and the
I/O module parameters are compared. If they differ, the “Parameter
Comparison” dialog appears. This dialog is described below.
•
“Parameter Comparison” dialog:
Figure 37: “Parameter Comparison” Dialog
