146 Commissioning
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
7.8.1.29 “DHCP Configuration” Page
The settings for the DHCP service are shown on the “DHCP Configuration” page.
7.8.1.29.1 “DHCP Configuration Xn” Group
Table 89: WBM “DHCP Configuration” – “DHCP Configuration Xn” Group
Parameter
Explanation
Service active
Enable or disable the DHCP service for the interface
Xn.
IP Range
Enter here a range of available IP addresses.
Lease time (sec)
Specify the lease time here in seconds. 120
seconds are entered by default.
Static hosts/
Static host n
This displays the static assignments of MAC IDs to
IP addresses. If no assignment was defined, “No
static hosts configured” is displayed.
New static host
Enter here a new static assignment, e.g.,
“01:02:03:04:05:06=192.168.1.20” or
“hostname=192.168.1.20.”
You can enter 10 assignments.
Click on
[Submit]
to accept the changes. The changes will be effective
immediately.
Click on
[Add]
to accept a new assignment. The change is effective immediately.
Click on
[Delete]
to delete an existing assignment. The change is effective
immediately.
