90 Commissioning
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
5.
Click
[Identify]
to read in and identify the connected controller.
6.
Select the “Network” tab:
Figure 38: “WAGO Ethernet Settings” – “Network” Tab
7.
To assign a fixed address, select “Static configuration” on the “Source” line
under “Input”. DHCP is normally activated as the default setting.
8.
In the column “Input” enter the required IP address and, if applicable, the
address of the subnet mask and of the gateway.
9.
Click on
[Write]
to accept the address in the controller. (If necessary,
“WAGO Ethernet Settings” will restart your controller. This action may
require about 30 seconds.)
10. You can now close “WAGO Ethernet Settings”, or make other changes
directly in the Web-based Management system as required. To do this,
click on
[WBM]
at the right in the window.
