WAGO-I/O-SYSTEM 750
Commissioning 111
750-8207 PFC200 CS 2ETH RS 3G
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
7.8.1.7 “Configuration of Host and Domain Name” Page
The settings for the general TCP/IP parameters are found on the “Configuration
of Host and Domain Name” page.
7.8.1.7.1 “HostName” Group
Table 48: WBM “Configuration of Host and Domain Name” Page – “Hostname” Group
Parameters
Explanation
Currently used
If you have selected dynamic assignment of an IP
address via DHCP, the name of the host currently
being used is displayed.
Configured
Enter here the hostname of your controller to be
used if the network interface is changed to a static
IP address or if no hostname is transmitted with a
DHCP response.
Click
[Submit]
to apply the change. The change is effective immediately.
If a hostname is supplied via a DHCP response, this is enabled in the system. If
there are several network interfaces with DHCP always the last received hostname
is valid.
If only the hostname configured here is to be valid, the configuration of the DHCP
server must be adapted so that no hostnames are transferred in the DHCP
response.
7.8.1.7.2 “Domain Name” Group
Table 49: WBM “Configuration of Host and Domain Name” Page – “Domain Name” Group
Parameters
Explanation
Currently used
The domain name currently used is displayed.
It may differ from the configured domain name if you
have selected dynamic assignment of an IP address
via DHCP or BootP.
Configured
Enter the domain name.
The default entry is “localdomain.lan”.
Click
[Submit]
to apply the change. The change is effective immediately.
If a domain name is supplied via a DHCP response, this is enabled in the system.
If there are several network interfaces with DHCP, the last received domain name
is always valid.
If only the domain name configured here is to be valid, the configuration of the
DHCP server must be adapted so that no domain names are transferred in the
DHCP response.
