WAGO-I/O-SYSTEM 758
Configuration
43
758-916 WLAN ETHERNET Gateway 2.4 GHz
Manual
Version 1.0.1, applicable from HW/SW Version 01/01
Table 17: WBM section “System Overview”
Parameter
Value
(example)
Description
General
Firmware
(“2.3.5”)
Display of the WEG firmware version
Wireless LAN
Status
Operating Mode
(“Infrastructure”)
Display of the network type
MAC Address
(“00:12:F3:12:FE:76”) Display of the WLAN MAC address
Status
(“Not Connected”)
Display of the WLAN link status
LAN Network
IP Address
(“192.168.1.99”)
Display of the WEG IP address
Subnet Mask
(“255.255.255.0”)
Display of the network mask
Default Gateway
(“192.168.1.99”)
Display of the gateway
IP Assignment
(“Static”)
Display of the IP assignment method
Ethernet MAC
address
(“00:12:F3:0F:D6:1C”) Display of the ETHERNET MAC
address
LAN Status
(“Link up”)
Display of the LAN link status
Clicking the
[Stop Automatic Update]
or
[Start Automatic Update]
button
respectively stops or starts automatic update of the information displayed.
7.4.4
“Network Settings” Section
You can perform network configuration in this section.
Figure 22: WBM section “Network Settings”
Please note the interaction with other devices in the network!
Changes to the network settings of a device can affect other devices in the same
network. An improper configuration, e.g., duplicate assignment of the same IP
address, can cause devices to not work as intended. Therefore, always make sure
that the configuration is correct especially when devices are configured to
function as DHCP servers.
