40
Connect Devices
EPSITRON® COMPACT Power
787-1202 / -1212 / -1216 / -1226 EPSITRON® COMPACT Power
Manual
Version 1.0.0
5.1.1.1 Connecting Using a Tool
You have to use a screwdriver or an operating tool to connect the following
conductors:
•
Fine-stranded conductors without ferrules
•
Fine-stranded conductors with uninsulated ferrule, cross section
≤
0.5 mm²/AWG 22
Proceed as follows:
1.
To open the spring clamp, depress the orange push-button with a tool.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the spring clamp connection, release the push-button. This secures
the conductor.
5.1.1.2 Directly Inserting Conductors
The following conductors can be inserted directly without tools:
•
Fine-stranded conductors with insulated ferrules for all permissible cross
sections
•
Fine-stranded conductors with uninsulated ferrules, cross section
> 0.5 mm²/AWG 22
•
Solid conductors with a cross section > 0.25 mm²/AWG 24
Pos: 50.4 /Serie 787 (
EPSITRON
)/Anschli eß en/Anschlüsse 787- 12xx - Zi ehen und Stecken picoMAX® @ 19\mod_1400578289768_21.docx @ 154292 @ 344554 @ 1
5.1.2
WAGO
picoMAX
®
Connectors
WAGO’s
picoMAX
®
pluggable connectors enable you to prewire devices to
expedite device installation and avoid rewiring during device replacement.
The procedure for removal and connection is the same for both WAGO plug
connectors.
WAGO
picoMAX
®
connectors consist of a male header (fixed in the device) and a
female connector (pluggable).
Additional information on
picoMAX
®
is available in the catalog “
picoMAX
®
‒ The
Pluggable Connection System” or online at www.wago.com.
5.1.2.1 Status at delivery
When delivered, the female connectors are plugged into the device.
