787-1226
Installation and Removal
26
Product manual | Version: 1.0.0
Compact Power Supply
Mounting on the DIN Rail
Mount the product per EN 60715 by snapping it onto the DIN rail without any tools.
1
2
3
4
Figure 16: Mounting the Product on the DIN rail
1. Tilt the product slightly.
2. Place the product, with its DIN rail guide, on the top edge of the DIN rail.
3. Press the product onto the DIN rail.
4. Press the product against the bottom fastener until you hear it lock into place.
ð
If the product does not lock into place automatically, pull down the DIN rail mount-
ing/removal latch with a screwdriver or operating tool while pressing the product
onto the bottom fastener.
5. Gently shake the product to ensure that it is correctly locked into place.
6. To ensure secure fastening on the DIN rail, fit end clips on either side of the product
(with a block arrangement: on either side of the product).
Removing from the DIN Rail
1
2
Figure 17: Removing the Product from the DIN Rail
1. To remove the product, pull down the DIN rail mount/removal latch.
ð
Use a screwdriver or an operating tool.
ð
The product is now unlocked.
