787-1226
Security
Product manual | Version: 1.0.0
9
Compact Power Supply
2
Security
This section contains safety rules that must be followed for hazard-free use of the prod-
uct.
This section is aimed at the following target groups:
• Planners and installers
• Operators
• Qualified assembly personnel
• Qualified installation personnel (electrical installation, technician network installation
etc.)
• Qualified operating personnel
• Qualified service and maintenance personnel
Obey the following safety rules:
2.1 General Safety Rules
• This documentation is part of the product. Therefore, retain the documentation during
the entire service life of the product. Pass on the documentation to any subsequent
user of the product. In addition, ensure that any supplement to this documentation is
included, if necessary.
• The product must only be installed and put into operation by qualified electrical special-
ists per EN 50110‑1/-2 and IEC 60364.
• Comply with the laws, standards, guidelines, local regulations and accepted technol-
ogy standards and practices applicable at the time of installation.
2.2 Requirements for Special Applications
Special Notes for Use per EN 60335-1
When using the product in accordance with EN 60335-1, also observe the following
notes:
• Take into account the space required for the product (
8
).
• Maintain the minimum clearances between the product and adjacent components
(
8
).
• Note the positions of the various mounting options (
8
• Keep the ventilation openings free.
• Install the product so that it is possible to subsequently disconnect the product from the
power supply (e.g., by installing a cut-off device that complies with the relevant installa-
tion requirements).
Special Notes on Use as a Built-In Installation Device
When using the product as a built-in installation device (building installation), also ob-
serve the following information:
