144 Appendix
WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
“Custom Routes” Group
Each configured static route has its own area in the display. If no static routes
have been entered, “(no custom routes)” is displayed.
Table 74: WBM “Routing” Page – “Custom Routes“ Group
Parameter
Explanation
Enabled
Specify whether the selected route should be used.
Disabled
The route is not used.
Enabled
The route is used.
Destination Address
Specify whether any network devices or only a
specific network device or device pool should be
accessible.
Default
Any network devices can be
reached.
Network address
Only a specific network device
or device from the specified
address pool can be reached.
Destination Mask
Enter the subnet mask of the device.
If “default” is entered for Destination Address, the
value “0.0.0.0” must be entered.
Gateway Address
Enter the address of the gateway.
If the “Interface” input field is empty, an entry is
required here. If a value is entered in the “Interface”
input field, the input here is optional.
Gateway Metric
Set the number used as the metric.
When there are multiple routes with the same
destination address and destination mask, the
metric specifies the gateway to which network data
packets are first sent. Priority is given to routes with
a lower value for the metric.
The lowest value is 0.
The highest value is 2³² - 1 = 4294967295.
Interface
Enter an interface via which the packets sent to the
destination address are routed. Bridges (br0-br3) as
well as modems (wwan0) or VPN interface names
can be used.
If the “Gateway Address” input field is empty, an
entry is required here. If a value is entered in the
“Gateway Address” input field, the input here is
optional.
Click the
[Submit]
button to apply the changes. The changes take effect
immediately.
To add a new route, click the
[Add]
button. The change takes effect immediately.
Click the
[Delete]
button to delete an existing route. The change takes effect
immediately.
