128 Appendix
WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
“Project Details” Group
This group appears if the controller supports the CODESYS V2 runtime system
and CODESYS V2 is set as the runtime system.
Table 62: WBM “PLC Runtime Information” Page – “Project Details” Group
Parameter
Explanation
Date
The last save date of the project is displayed.
Title
The project information that the programmer has
entered in the PLC program is displayed here (in the
programming software under Project > Project
Information ...).
The information only appears in an executed PLC
program.
Descriptive texts up to 1024 characters long are
given under “Description.”
Version
Author
Description
Checksum
The calculated checksum of the project is displayed.
“Task <n>” Group(s)
One dedicated group is displayed for each task when the PLC program is
executed. As a rule, only the group title is displayed with the task number, the
task name and the task ID.
This group(s) appear(s) if the controller supports the CODESYS V2 runtime
system and CODESYS V2 is set as the runtime system.
Table 63: WBM “PLC Runtime Information” Page – “Task n” Group(s)
Parameter
Explanation
Cycle count
Number of task cycles since the system start
Cycle time (µsec)
Currently measured task cycle time for the task
Cycle time min (µsec)
Minimum task cycle time for the task since the
system start
Cycle time max (µsec)
Maximum task cycle time for the task since the
system start
Cycle time avg (µsec)
Average task cycle time since the system start
Status
Task status (e.g., RUN, STOP)
Mode
Task execution mode (e.g., in cycles)
Priority
Set task priority
Interval (msec)
Set task interval
