Touch Panel Marine Line
Commissioning 165
762-6xxx/8000-000x TP 600
Manual
Version 1.1.0
8.7.3.15 “DHCP Configuration Xn” Group
Table 148: WBM “DHCP Configuration” – “DHCP Configuration Xn” Group
Parameter
Explanation
Service active
Enable or disable the DHCP service for the interface
Xn.
IP Range
Enter here a range of available IP addresses.
Lease time (sec)
Specify the lease time here in seconds. 120
seconds are entered by default.
Static Hosts
This displays the static assignments of MAC IDs to
IP addresses. If no assignment was defined, “No
static hosts configured” is displayed.
Add Static Host
Below you can enter MAC addresses or host names
and IP addresses.
MAC Address or Hostname
Enter here a new static assignment, e.g.,
“01:02:03:04:05:06=192.168.1.20” or
“hostname=192.168.1.20.”
You can enter 10 assignments.
Ip Address
Enter here an IP address.
You can enter 10 assignments.
Click on
[Submit]
to accept the changes. The changes will be effective
immediately.
Click on
[Add]
to accept a new assignment. The change is effective immediately.
Click on
[Delete]
to delete an existing assignment. The change is effective
immediately.
8.7.3.15.1 “Modbus Services Configuration” Page
The settings for various Modbus services are shown on this page. The groups
are only visible if the
e!
RUNTIME
system is enabled. Otherwise an information
text is displayed.
8.7.3.15.2 “Modbus TCP” Group
Table 149: WBM “Modbus Services Configuration” Page – “Modbus TCP” Group
Parameter
Explanation
Service active
Disable or enable the Modbus/TCP service here.
Click the
[Submit]
button to apply the changes. The change is effective
immediately.
8.7.3.16 “Modbus UDP” Group
Table 150: WBM “Modbus Configuration Services” Page – “Modbus UDP” Group
Parameter
Explanation
Service active
Disable/enable the Modbus-UDP service here.
