Touch Panel Marine Line
Commissioning 153
762-6xxx/8000-000x TP 600
Manual
Version 1.1.0
8.7.3.3.2 “Interface Xn” Groups
One group (“Interface X1” / “Interface X2”) is displayed for each connection.
Table 124: WBM “Ethernet Configuration” Page – “Interface Xn” Groups
Parameter
Explanation
Enabled
You can enable or disable the interface.
Autonegotiation on
When Autonegotiation is enabled, the connection
modalities are negotiated automatically with the peer
devices.
Speed/Duplex
Select the transmission speed and the duplex
method:
10 Mbit half-duplex
Information can only be
sent or received.
100 Mbit half-duplex
10 Mbit full-duplex
Information can be sent
and received
simultaneously.
100 Mbit full-duplex
Click
[Submit]
to apply changes. The changes are effective immediately.
8.7.3.4 “Host/Domain Name” Page
The settings for general TCP/IP parameters are located on this page.
8.7.3.4.1 “Hostname” Group
Table 125: WBM “Host/Domain Name” Page – “Hostname” Group
Parameter
Explanation
Currently used
If you have selected dynamic assignment of an IP
address via DHCP, the name of the host currently
being used is displayed.
Configured
Enter the hostname of your panel here; it is then
used if the network interface is changed to a static
IP address or if no hostname is assigned per DHCP
response.
Click the
[Submit]
button to apply a change. To reset the input field, click the
[Clear]
button. The change takes effect immediately.
If a hostname is supplied via a DHCP response, this is enabled in the system. If
there are several network interfaces with DHCP, the last received hostname is
always valid.
If only the hostname configured here is to be valid, the configuration of the DHCP
server must be adapted so that no hostnames are transferred in the DHCP
response.
