2787-2146 (/0000-00x0)
Installation and Removal
32
Product manual | Version: 1.2.2
Power Supply Pro 2
Mounting per DNV GL
The following instructions apply for installation per DNV GL:
• Mount the product on a DIN-rail (210-197 or 210-118).
• Place an end bracket on the left and right of the product (249-117).
Mounting on the DIN-35 Rail
A
B
Figure 15: Mounting
Install the product as per EN 60715 by snapping it onto the DIN-35 rail (see figure
“Mounting”):
1. Place the product, with its DIN-35 rail guide, on the top edge of the DIN-35 rail.
2. Press the product onto the DIN-35 rail [A] while simultaneously pulling on the latch
(I) on [B] until it locks into place.
3. To ensure secure fastening on the DIN-35 rail, fit end stops on either side of the
product (e.g., order no.
249-197
).
Removing from the DIN-35 Rail
D
C
Figure 16: Removing
1. To remove (see figure “Removing”), pull the latch (I) down [C], using a screwdriver or
an operating tool.
2. Pivot the product to remove it from the DIN-35 rail [D].
