WAGO-TO-PASS® 761
Operation
43
761-510 GPRS Modem, RS-232
Manual
Version 1.0.2
Pos: 45.7 /Serie 761 (TO-PASS)/Bedienen/AT-Befehle 761-510 @ 5\mod_1245676449406_21.doc @ 35858 @ 2 @ 1
6.4
Supported AT Commands in Terminal Mode
All AT commands not listed in the following return
OK
even if the command is
not executed.
Table 12: Switching from transparent phase to command phase
+++
Switching from transparent phase to command phase
Effective command
Command
+++
Response
This command is only available during data calls. The character
++ ends the transfer of data and switches to command
phase. You can then enter AT commands while the data connection
to remote stations continues.
Parameter -
Note
To return to transparent phase, use the ATO command. The
character ++ cannot be completed with <CR>>LF>.
Table 13: Repeat last command line
A/
Repeat last command line
Effective command
Command
A/
Response
Dependent on last command.
Parameter -
Note
The character string A/ cannot be completed with <CR>>LF>.
Table 14: Answer call
ATA
Answer call
Effective command
Command
ATA
Response CONNECT[<text>]
Data connection established
OK
Voice connection established or for
command stop
NO CARRIER
Connection not established
Parameter -
Note
See ATX for the CONNECT messages
