44 Operation
WAGO-TO-PASS®
761
761-510 GPRS Modem, RS-232
Manual
Version 1.0.2
Table 15: Dialing and connection setup
ATD
Switching from transparent phase to command phase
Effective command
Command
ATD[<n>]
Response
If the connection is not established:
NO DIALTONE
BUSY
NO CARRIER
NO ANSWER
If a data connection is established successfully:
CONNECT[<text>]
Parameter <n>:
Character string of dial digits (0-9) and optional V.25 special dial
characters (* , #, +, A, B, C)
Note -
Table 16: Switch ON/OFF local echo
ATE
Switch ON/OFF local echo
Effective command
Command
ATE[<value>]
Response OK
Parameter <value>:
0:
Local
echo
OFF
1:
Local echo ON <default setting>
Note
The setting determines whether the device echoes the characters
from the equipment connected locally in command phase.
Table 17: Release existing connection
ATH
Release existing connection
Effective command
Command
ATH
Response OK
Parameter -
Note
After entering this command, all existing connections are released.
Before entering commands, use
+++
to switch to command phase
in the existing connection.
