WAGO-TO-PASS® 761
Operation
47
761-510 GPRS Modem, RS-232
Manual
Version 1.0.2
Table 23: Set result code format
ATV
Set result code format
Effective command
Command
ATV[<value>]
Response
0
(if "numeric code" is enabled)
OK
(if "verbose code" is enabled)
Parameter <value>:
0: Information
<text><CR><LF>
Result
code
(short format):
<numeric code><CR>
1: Information
<CR><LF><text><CR><LF>
Result code
(long format):
<CR><LF><verbose code><CR>
<default setting>
Note
This parameters defines the content of the header and trailer
transferred with the result codes and responses.
Text messages and numeric messages:
OK
0
Command executed, no errors,
restart
CONNECT
1
Connection established
RING
2
Ring detected
NO CARRIER
3
Connection was not established or
interrupted
ERROR
4
Invalid command
NO DIALTONE
6
No dial tone, cannot
dial, wrong mode
BUSY
7
Remote station busy
CONNECT 2400/RLP 1
Connection with 2400 bps and radio
Link
protocol
CONNECT 4800/RLP 1
Connection with 4800 bps and radio
Link
protocol
CONNECT 9600/RLP 1
Connection with 9600 bps and radio
Link
protocol
Table 24: Hardware flow control ON/OFF
AT\Q
Hardware flow control ON/OFF
Effective command
Command
AT\Q<n>
Response OK
Parameter <n>:
0: Hardware flow control (RTS/CTS) OFF
3:
Hardware flow control (RTS/CTS) ON
Note -
