►
Never use electrical equipment in the bath or under the shower.
►
Always position or store electrical equipment where it cannot fall into water (e.g. washbasin). Prevent electrical
equipment from coming into contact with water and other liquids.
►
Only use and store the appliance in dry rooms.
►
As additional safety measure, it is recommended that a tested residual current appliance (RCD) with a residual
operating current of not more than 30 mA be installed in the bathroom circuit.
Danger of explosion!
►
Never use the appliance where aerosol (spray) products are being used or where oxygen is released.
Warning! Injuries due to incorrect handling.
►
To prevent injury, never use the appliance if the blade set is damaged.
►
Always switch the appliance off before storage, as the appliance can fall down due to the vibrations.
Handle with care! Damage due to incorrect power supply.
►
Only operate the appliance with an alternating current and with the voltage stated on the nameplate.
Handle with care! Injuries due to incorrect handling.
►
Only use accessories recommended by the manufacturer.
►
Never insert or allow objects to fall into the openings of the appliance.
►
Do not hold the appliance by the mains cable to carry it, and do not use the mains cable as a handle.
►
When disconnecting the appliance from the mains, never pull on the mains cable or on the appliance itself.
►
Do not wind the mains cable around the appliance.
►
Keep the mains cable and appliance away from hot surfaces.
►
Make sure that the mains cable is not twisted or kinked when using or storing the appliance.
►
Always store the appliance with the blade guard in place.
►
Do not expose the appliance to temperatures below 0°C and above +40°C for any length of time. Avoid direct
exposure to sunlight.
PRODUCT DESCRIPTION
Description of parts (Fig. 1)
A
Blade set
B
Cutting length adjustment lever
C
On/off switch
D
Mains cable
E
Adjusting screw
F
Blade guard
G
Oil for blade set
H
Cleaning brush
Not pictured
Attachment combs and various accessories (depending on model)
Technical data
Drive unit:
Quiet oscillating armature motor
Emission sound pressure level:
max. 60 dB(A) @ 25 cm
Vibration:
< 2.5 m/s
2
The appliance is safety insulated and radio screened. It meets the requirements of EU Electromagnetic Compatibility Directive 2004/108/EC and Machinery Directive
2006/42/EC.
Declaration of conformity: See page 7.
OPERATING INSTRUCTIONS
Preparation
Keep the packaging material for safe storage or transport later.
f
Check that the contents are complete.
f
Check all the parts for possible transport damage.
Safety
Handle with care! Damage due to incorrect power supply.
f
Only operate the appliance with an alternating current and with the voltage stated on the nameplate.
Mains operation
1. Oil the blade set (Fig. 6).
2. Insert the appliance plug into the mains socket.
3. Switch on the appliance using the on/off switch (Fig. 2a) and, after use, switch it off again (Fig. 2b).
Accessories are available from your dealer.
Summary of Contents for 8467
Page 1: ...PROFESSIONAL MAINS CLIPPER...
Page 7: ......
