6
Deluxe Chrome Pro Clipper
CLIPPER MAINTENANCE
Your WAHL clipper blades were oiled and aligned before leaving our
factory, however it is possible for blades to get bumped out of alignment.
Blades must be realigned if they have been removed for cleaning or
replacement. To determine if realignment is necessary, compare your
clipper blades with this sketch.
1. End of top blade teeth should be .025” to .050” (.64mm to 1.27mm) back
from bottom blade. This is important so that the clipper does not cut too
close or allow the moving cutter to touch the skin.
2. Extreme left hand tooth of top blade must be covering or to the left of
the first small tooth of bottom blade.
3. Extreme right hand tooth of top blade must be touching the big tooth on
the bottom blade.
If blade alignment is incorrect, add a few drops of oil to the blades, turn
clipper on for a few moments, turn off and unplug. Loosen screws slightly
and adjust. Tighten screws after blade is aligned
1. Put a few drops of wahl clipper oil on blades.
2. Bottom blade.
3. Top blade.
4. Blade slide only on adjustable blade clippers.
5. Blade lever (not on all models).
6. Power screw.
7. Switch.
8. Case.
9. Hanging loop.
