10
LITHIUM PRO SERIES CLIPPER
full cutting stroke without becoming hot from friction.
b. Flushes abrasive particles and hair out from
between the blades.
CHANGING THE BLADE SET
Warning! Injuries and material damage due to
incorrect handling
.
1.
Switch the appliance off using the on/off switch
(fig.1a/b) and disconnect from the power supply.
2.
Undo the screws on the blade set, (T20 Torx
screwdriver required) remove the bottom blade and
the top blade (fig. 5).
3.
To replace the blade first check that the tension
spring (fig 6c) is properly located under the lug in
centre of housing (fig 6b).
4. Turn motor cam so that the pin is in the top position
(fig 6a).
5.
Place the cam follower (fig 6e) on to the small blade
(fig 6f) ensure the cam follower is positioned as
shown.
6. Put a smear of grease into the cam slot on cam
follower (fig 6d).
7. Position the small blade assembly on to the head
of the clipper, ensure the ends of the spring line-up
with the slots on the cam follower (fig 6g) and the
cam slot lines-up with the pin on the motor cam.
8. Press and hold blade assembly against head of
the clipper with one hand, take care as you will be
pushing against the spring tension, with the other
