11
LITHIUM PRO SERIES CLIPPER
hand slide the large blade over the top of the small
blade, hold tight with one hand and replace the
blade screws.
The torx screws are self-aligning, no further blade
alignment is required.
Ensure screws are tight then Oil blade assembly
and test. If blade assembly is not moving correctly
check that spring and cam are correctly aligned with
the cam follower (fig 6).
Warning! Injuries due to incorrect handling.
CLIPPER USE AND MAINTENANCE
• A fully charged appliance will deliver a maximum of
120 minutes of continuous trimming.
• To ensure maximum battery performance the
appliance should be connected to the transformer
and fully recharged after use. Once charged remove
the appliance from the transformer and store in
a cool, dry place. The transformer is designed to
continuously charge the battery without overcharging.
•
Use only the power source specified on the charger
transformer.
• Feed the appliance through the hair only as it will cut.
Feeding too fast, wedges the hair clippings between
the blades, preventing them from cutting properly.
DO NOT CUT WET HAIR.
• It is acceptable for the unit to become somewhat
warm during normal use.
•
Avoid pushing the blades into the skin, taking extra
care around sensitive areas or areas where folds of
skin are present. The large flat surface of the blade