ENGLISH
de
en
fr
it
es
pt
nl
da
sv
no
fi
tr
pl
cs
sk
hr
hu
sl
ro
bg
ru
uk
et
lv
lt
el
ar
14
Changing the blade set
1. Switch the appliance off using the on/off switch
(Fig. 2
ⓑ
) and disconnect from the power supply.
2. Undo both screws on the blade set; remove the bottom
blade and the top blade (Fig. 8).
When assembling, the bottom blade and the top blade
should be aligned as follows:
3. Set the locking switch (B) for the cutting length
(Fig. 3
ⓐ
) and the adjustment lever (Fig. 4
ⓑ
) to the
shortest cutting length.
4. Place the top blade with groove on the wedge-shaped
plastic guide and press it down at the back so that the
drive pin grips the blade cutout.
5. Position bottom blade and reinsert the two screws.
6. Before tightening the screws, align the bottom blade so
that there is a gap of 0.5 mm to 1.0 mm between the
front edge of the bottom blade and the front edge of the
top blade (Fig. 7).
7. Tighten both screws (Fig. 8).
8. Check the alignment of the bottom blade again.
Problem elimination
Blade set is cutting badly.
Blade set is pulling hair out.
Cause: Blade set is dirty.
f
Clean and oil the blade set (Fig. 6).
Cause: Blade set is worn out.
f
Replace blade set (Fig. 8).
Skin injury
Cause: Too much pressure on the skin.
f
Reduce pressure when cutting close to skin.
Cause: Cutting angle is too steep.
f
Hold appliance flatter to the skin.
Cause: Damaged blade set.
f
Check whether the blade edges were damaged during
use and replace the blade set if necessary.
Cause: Gap between the front edge of the bottom blade
and the front edge of the top blade is not correctly aligned.
f
Align the bottom blade (Fig. 7).
Appliance is not working.
Cause: Defective power supply.
f
Make sure that contact between the appliance plug and
the socket is faultless. Check the mains cable for pos-
sible damage.
In the event that this information does not help you resolve
your problem, please contact our service centre. Never
attempt to repair the appliance yourself!
Disposal
Handle with care! Environmental damage in
the event of incorrect disposal.
f
Correct disposal will ensure environmental
protection and prevent any potentially harmful
impact on people and the environment.
Adhere to the relevant legal requirements when disposing
of the appliance.
Information on the disposal of electrical and electronic
appliances in the European Community:
Within the European Community, national regula-
tions are specified for the disposal of electrical
appliances, based on EU Waste Electrical and
Electronic Equipment Directive 2012/19/EC
(WEEE). In accordance with this, the appliance
can no longer be disposed of with the local or
domestic waste.
The appliance will be accepted free of charge by
local collection points or recycling centres.
The packaging for this product is made from
recyclable materials. Dispose of this in an environ-
mentally friendly manner by recycling it.
