8
LITHIUM ION TRIMMER
OPERATING INSTRUCTIONS
Before the appliance is used for the first time it should be
charged for 1 hour.
CHARGING THE RECHARGEABLE BATTERY
Connect the plug-in transformer to the power supply (fig1).
Ensure the appliance is switched off, otherwise it cannot be
charged (fig2b).
Place the appliance on the charging stand. Whilst charging the
charging indicator will illuminate.
The charger indicator will go out when removed from the
charging stand.
We recommend you only charge your appliance when its
performance has deteriorated noticeably.
Longer charging times do not damage the appliance.
It takes approximately 1 hour for the appliance to be fully
charged. This will allow 75 minutes run time.
Use only the charging transformer supplied with this kit.
DO NOT attempt to charge with any other transformer.
FOR CORDED OPERATION
Disconnect the power cord from the back of the stand and
connect to the receptacle in the bottom of the unit. If your
battery is completely run down, allow the unit to charge for 1
Minute (switched off) before using as a corded unit.
If the cord is left attached to the unit when not in use, the cord
will automatically charge the unit when left in the OFF position.
CHANGING THE BLADE SET
The blade set can be removed by pushing the blade set away
from the housing in the direction of the arrow see (fig 5a).
To replace blade set position it with the hook in the slot on the
housing and press until it clicks into place (fig 5b).
