9
LITHIUM ION TRIMMER
TROUBLESHOOTING
If your trimmer does not seem to be operating or charging
properly, please check the following:
1.Check outlet to make sure it is working properly by plugging
in another appliance.
2.Be sure the trimmer is properly connected to the recharging
receptacle, all connections are secure and the switch on the
trimmers is turned OFF.
3.If your electricity is connected to a master power switch,
we suggest the trimmer be disconnected from the charger
anytime the master switch is off. Leaving the unit plugged into
dead outlet or an unplugged charger will drain the battery.
4.If the trimmer does not run and it is completely charged,
turn the unit ON and pinch or push the blades manually. Oil
may have dried out between the blades, so they may be
temporarily stuck together.
5.Your trimmer contains a rechargeable battery if and when a
replacement is required contact Wahl Customer Service or an
authorised service centre for advice on replacement.
CLEANING AND MAINTENANCE
Never immerse the appliance in water.
Remove the attachment comb after each use and clean the blade
set using the cleaning brush.
Remove the blade set (fig 5) and clean the blade, by using your
cleaning brush (fig 6).
The charging contacts of the appliance must be kept clean. Use
only a slightly damp cloth for cleaning the housing and charging
stand never use solvents or scouring agents.
Oil the blade set regularly using the oil supplied (fig 7) to maintain
the cutting performance and ensure a long service life. Replace
the attachment comb to protect the blade when not in use.
The blade set should be replaced if cutting performance is
reduced after extended use.
