805.245.005
Date: January 10, 2017
5
Connecting the Winch 50
Power supply
The Winch 50 must be connected to 208-240VAC.
Power is connected to the yellow Neutric Powercon TRUE1 connector.
By supplying power to the winch, the display will show a startup screen and then change to
DMX CONTROL .
START CHAN 1
DMX
DMX is connected to the male 5-pole XLR connector.
The DMX LED will light constantly when receiving a DMX signal and it will flash when no
DMX is received.
Pinout:
DMX IN
DMX OUT
Pin 1 = GND
Pin 1 = GND
Pin 2 = Data –
Pin 2 = Data –
Pin 3 = Data +
Pin 3 = Data +
Pin 4 = NC .
Pin 4 = NC.
Pin 5 = NC.
Pin 5 = NC.
Mounting for winch
The winch is mounted in 4 slim couplers sitting on the top plate. It is important to use all for slim
couplers for mounting because the load is not evenly distributed across the winch.
Without all 4 mounting points the winch will hang at an angle and have a significantly reduced
lifetime.
