JENS JUULS VEJ 1, 8260, VIBY, DENMARK
WWW.WAHLBERG.DK
TELEPHONE: +45 86 18 14 20
380.805.002
5
DATE: 2021-03-25
Usage
The manipulator, although advanced, is simple to use. Before first use please demount any load
and secure the area.
Start up guide
1.
Connect power and DMX to the manipulator. Wait for the intro screen to pass.
2.
Set channel 4 between 50% and 55%. This enables the manipulator to run.
3.
Set channel 1 and 2 to the desired position. 0% is closest to the motor box and 100%
is furthest away from the motor box. Set channel 3 to the desired speed and the
wagon will go there.
4.
To limit the range available use channel 5 and 6. Channel 5 shifts the 100% position
away from the top and channel 6 shifts the 0% position away from the bottom. Note
that the two channels must add up to less than 100%.
For smooth synchronous movement fading of 16-bit position should be used.
DMX Channel overview
Ch
Function
Description
1
Position HI
Rough position. MSB of the 16-bit position.
2
Position LO
Fine position. LSB of the 16-bit position.
3
Speed
Maximum speed of the manipulator.
4
Motor enable
Security channel.
50-55% enables the manipulator.
Any other value will disable the motor.
5
Shift TOP
limit
Shift the top limit down (100% position, furthest away from the motor
box). Setting this to 20% will mean only 0%-80% of the range is available.
6
Shift BOTTOM
limit
Shit the bottom limit up (0% position, closest to the motor box). Setting
this to 30% while channel 5 is at 20% means only 30%-80% range is
available.
LED indicators
DMX LED: ON means DMX is received.
BLINKING means DMX I missing. Check your connection.
ERROR LED: ON means the manipulator is disabled or an error has occurred.
OFF means the manipulator is enabled
Info screen information
By holding the down or up arrow different information screens are available. The
initial info screen only displays the current DMX start channel. Subsequent displays
have more information.
Display 1: DMX start channel
Display 2: (P)osition, (D)istance to wanted position, (W)anted position, (S)peed
Display 3: DMX channel input 1-4 and 5-8
