WWW.WAHLBERG.DK · TELEPHONE +45 86 18 14 20 · CELL PHONE +45 40 52 20 88 · EMAIL: mads@wahlberg.dk
3
Mounting
The shutter
The shutter should be mounted on a projector.
This can be done in several ways e.g. with duct
tape or Velcro.
It is important to make sure that the shutter is
mounted well and sits tightly on the projector, so
it does not move, when the motor turns the shutter
flap.
The Shutter flap
The shutter flap and the red washer (vibration damper) should
be mounted on the motor axle.
The red washer should be mounted between the motor and the
shutter flap, see the picture.
When the desired angle has been found, the disc can be
tightened with the small black screw, not too tight. For this you
may use the small screwdriver included with the projector
shutter.
Using the shutter
When the power and the DMX signal have been connected to the shutter, and the shutter
flap has been mounted, the projector shutter is ready for use.
By changing the percentage of the DMX address, the motor axle will turn forward or
backward following the DMX percentage.
The motor axle turns from 0 to 180 degrees, 0% equalling 0 degrees and 100% being 180
degrees
Technical specifications
Power supply:
120 – 230vAC 50/60Hz
Power consumption:
10 Watt.
Motor speed:
60 degrees - 0.16 sec.
DMX control:
DMX 512 1990 + DMX512A / 1 channel is used.
Weight shutter:
0,3 kg. / 10.5 ounces
Dimensions shutter box:
140 x 65 x 38 mm. / 5.5 x 2.6 x 1.5 inch. (L-W-H)
Plugs:
EU, US, AU or GB
