6
805.241.009
Date: October 14, 2016
Area of use:
The Winch is intended for indoor use only. It is designed for lifting and lowering material at the
weight and speed stated in "Technical Data". Any other use of the winch may result in a risk of
injury of persons or equipment damage.
Exceeding the load rating may cause failure of the equipment.
Use only approved rigging connectors to secure the load to the wire and do not wrap the wire
around the load as this will damage the wire and result in a risk of injury of persons or equipment
damage.
Do not modify the winch. Any modification you might need should be done by Wahlberg.
It is the customers' responsibility that any local restrictions concerning the use of the winch are
complied with.
For indoor use only!
Caution:
"To Reduce the Risk of Electric Shock or Injury: Use Indoors Only."
Caution:
"To reduce the risk of electric shock, do not expose to rain: Store indoors."
Overview:
MODE functions:
MODE 1
Positioning with auto reset.
MODE 2.
Positioning with manual reset
MODE 7
Manual run up (no DMX needed).
MODE 8
Manual run down (no DMX needed).
MODE 3, 4, 5, 6 Only if specified, otherwise the motor stops.
DMX channels:
DMX channel 1
Position rough. (Hi of a 16 bit DMX channel).
DMX channel 2
Position fine. (Lo of a 16 bit DMX channel).
DMX channel 3
Max speed.
DMX channel 4
Max travel top.
DMX channel 5
Max travel bottom.
DMX channel 6
Find TOP position, moving UP
DMX channel 7
Moving DOWN
Attention!
Before running the winch, it is important to put a counterbalance on the wire.
Either by putting some kind of weight in the snap hook or by manually holding the wire
back.
This is important, as the slack detection switch otherwise will be activated and the winch
will not run.
