10
246.805.201
Date: 2017-09-26
AC power
Warning! Read “Safety Information” on page 2 before connecting the winch 50 to
AC mains power.
Warning! For protection from electric shock, the Winch 50 must be grounded
(earthed). The power distribution circuit must be equipped with a fuse or circuit
breaker and ground-fault (earth-fault) protection.
Warning! Socket outlets or external power switches used to supply the Winch 50
with power must be located near the winch and easily accessible so that the winch
can easily be disconnected from power.
Power voltage
Warning! Check that the voltage range specified on the winch’s serial number label
matches the local AC mains power voltage before applying power to the winch. Do
not apply AC mains power to the fixture at any other voltage than that specified on
the winch’s serial number label.
Power cables and power plug
The Winch 50 requires a power input cable with a Neutrik powerCON TRUE1 NAC3FX-W
cable connector for AC mains power input. The cable must meet the requirements
listed under “Protection from electric shock” on page 2.
Wahlberg Motion Design can supply the PowerCON input connector without a cable.
If you install a power plug on the power cable, install a grounding-type (earthed) plug
that is rated 20 A minimum. Follow the plug manufacturer’s instructions. The Neutrik
assembly guide below shows standard wire color-coding schemes and some possible pin
identification schemes; if pins are not clearly identified, or if you have any doubts
about proper installation, consult a qualified electrician.
By supplying power to the winch, the display will show a start-up screen and then
change to:
Summary of Contents for Winch 50 Double
Page 12: ...12 246 805 201 Date 2017 09 26...