25
246.805.201
Date: 2017-09-26
LED Functions
DMX LED
The DMX lamp will be steady green when receiving a DMX signal.
The DMX lamp will flash green if no DMX signal is present.
Error LED
The error LED will light red if there is an error.
Reset error is done by setting DMX channel 4 to 0.
When the Error LED lights red, there will also be an error description in the display.
Error and error codes:
Error
Possible solution
Winch will not start, display shows nothing. Check if the winch is connected to mains power.
Check if the fuse in the winch is intact
Winch will not start, DMX lamp is blinking.
Check DMX signal
The wire is not wound up on the drum
correctly.
Manually lower the wire totally off the drum,
while controlling that the wire comes out of the
winch evenly. Afterwards the wire is rolled back
onto the drum.
Reset the top position afterwards.
Display says “Not in Pos”
The winch cannot move to its position, this usually
occurs when the load is high. To solve this go into
the menu and increase the Minimum speed up.
Power failure
The winch will stop at power failure. When the power is re-established, the winch has
to be reset before it is ready to use.
It is advisable to set all the DMX channels on 0% before the power is re-established.
Summary of Contents for Winch 50 Double
Page 12: ...12 246 805 201 Date 2017 09 26...
