29
246.805.201
Date: 2017-09-26
Winch 50 - Cheat Sheet
How to get started
1.
Place / Rig the winch high so there is space for the wire to move without hitting the
floor.
2.
Put on counterweight on the winch loop, minimum 3.5 kilo.
3.
Connect to 230VAC –
The display is now shows the start-up message
4.
Set the DMX channel 4 between 50% and 55% -
Motor is now enabled
5.
Set the DMX channel 5 to 50%
−
Wait for the load to move to the top position (There is a 3s delay on this
channel).
−
When the load is in the top position, set channel 5 to 0%.
6.
Set DMX channel 6 to 50% wait for the wire loop to go 2 m down.
−
When the load is 2m out, set DMX channel 6 to 0% (There is a 3s delay on this
channel).
The travel range has now been set to: from the winch and 2 m down.
7.
Set DMX channel 1 to 100% and DMX channel 3 to 20%
The wire loop is now running to the top with 20 % speed.
8.
Set DMX channel 1 to 50% and DMX channel 3 to 50%
The wire loop is now running 1m down with 50 % speed.
Emergency stop switch (Only when emergency stop is enabled)
The emergency stop switch is connected to the female 4 pin XLR connector.
Pin 1 and Pin 2 should be connected to each other; otherwise the motor will not run.
Pin out:
Pin 1
GND
Emergency stop input
Pin 2
NC
Pin 3
NC
Pin 4
12-15 volt DC
Emergency stop input
Winch 50 - Cheat Sheet
DMX channels Function
1
Position rough (Hi of a 16 bit DMX channel)
2
Position fine (Lo of a 16 bit DMX channel)
3
Set the maximum speed
4
Motor Enable – between 50% and 55% to enable the motor output
5
Reset UP
6
Manual DWN
Intact wire
Before each use
−
Inspect the entire length of the
wire rope
for bends,
damage, wear, cut cord, corrosion and abuse.
−
Inspect the
wire wedge clamp
for damage, wear,
corrosion or abuse.
−
Check that the load is securely mounted
−
Check all limit switches.
−
Check the emergency stop (if enabled).
−
Check that the wire is winded neatly on the drum.
Warning! Do not use the winch if any damage or error is
found!
Broken wire
Inspection
points
Intact wire
Summary of Contents for Winch 50 Double
Page 12: ...12 246 805 201 Date 2017 09 26...