6
ATTACHING YOUR BICYCLE
Shift your bicycle chain into the smallest sprocket in the front and rear, then remove
your rear wheel. Install your bicycle on the KICKR CORE by aligning the the chain with
the smallest sprocket on the KICKR CORE and pressing down to fully seat the dropouts
on the KICKR CORE’s axle.
For bicycles with quick release -
Secure your
bicycle by tightening the quick release acorn
nut and clamping the quick release lever
shut. The quick release lever is “open” when
it curves away from the bicycle frame (5); the
lever is “closed” when it curves towards the
bicycle frame (6). The handle of the quick release skewer is always on the non-drive
(non cassette) side of the KICKR CORE.
Only use the provided quick release skewer
while using the KICKR CORE
.
For bicycles with thru axle -
Secure your bicycle by reinstalling
your bicycle’s thru axle (7) and
tightening to manufacturer
specifications (8).
P
SOLIDWORKS Educational Product. For Instructional Use Only.
SOLIDWORKS Educational Product. For Instructional Use Only.
(7)
(8)
PROTIP: Lift the front wheel up while pressing down on the saddle to ensure
the bicycle is fully seated on the trainer.
CAUTION! Failure to properly tighten the quick release skewer or thru axle may result
in property damage or personal injury. If you are unsure of the proper tension, please
consult your local bike shop or contact Wahoo Fitness for assistance. Do NOT ride the
KICKR CORE until the quick release skewer or thru axle is tightened.
Adapter C
12x142mm Configuration
(Adapter D)
12x148mm Configuration
(Adapter D)
FOR 142MM OR 148MM THRU AXLE
Adapters Needed: C and D
To be used with the 12mm thru
axle supplied with bicycle.
Note: You will have some adapters
left over.
Adapter A
130mm Configuration (Adapter B)
135mm Configuration (Adapter B)
FOR 130MM OR 135MM QUICK RELEASE
Adapters Needed: A and B
Quick release skewer
is included.
SOLIDWORKS Educational Product. For Instructional Use Only.
SOLIDWORKS Educational Product. For Instructional Use Only.
(5)
(6)
