Carina Indoor Surface Mount IP Intercom User’s Guide Page 15
v
3.0.0.20201022
Codecs
–
The Codec List is shown in preferred order from top to
bottom. This list may be rearranged by dragging and dropping the
codecs within the list.
Available codecs are: G.722 HD, DVI4 HD, G.726 fixed payload,
DVI4 Narrowband, G.711 uLaw, G.711 aLaw, G.729, OPUS.
Calls
–
Configure display behavior for inbound and outbound calls.
Relay control
–
When enabled, the intercom’s onboard relay
will be triggered for the duration of an active SIP call.
Inbound
–
Adjust settings for inbound calls.
Allowed
–
When inbound calls are set to “not allowed,” the
calls will be rejected immediately.
Priority
–
Priorities determine which audio event will take
precedence over other audio events. A higher priority event
will take over a lower priority event. If two events of the
same priority occur, they will be handled in the order
received.
Auto-Answer
–
When Auto-Answer is not enabled, an
inbound call will continue ringing until the Incoming Call
Timeout occurs. Auto-answer is enabled by default when
inbound calls are allowed.
Tone Notification
–
When enabled, a tone will be played
out of the intercom’s speaker just before a call goes active.
Outbound
–
Adjust settings for outbound calls.
Allowed
–
When disabled, outbound calls by any means
from this intercom are prevented.
Timers
Call Attempt Timeout
–
An unanswered outbound call
attempt will be automatically cancelled when this timer expires.
Default is 180 seconds.
