36
TROUBLESHOOTING GUIDE (cont)
The infeed and outfeed tables have been adjusted at the factory before shipment. There is a
possibility that they may have shifted due to it being dropped, rolled, or impacted during shipment,
and are no longer coplanar or parallel to the cutterhead. If you are getting undesirable results, a
check should be performed using a metal straight edge of at least 24” in length.
REMINDER: BE EXTREMELY CAREFUL when working around the cutterhead!!!
1. Locate the 2 screws holding the cutterhead guard bracket and loosen the screws “A” in FIG 10.
Grasp the guard and guard bracket as shown and slide up and pull out to remove. See FIG 11
NOTE
: The cutterhead guard has a tension return spring. The tension on this spring is set at the
factory. When the guard is installed properly it should return to the fence automatically after the
work piece has passed over the cutterhead. Be sure the guard is functioning properly every time
before using the jointer.
Summary of Contents for 50180CC-WHD
Page 13: ...13...
Page 34: ...34 TROUBLESHOOTING GUIDE cont...
Page 35: ...35 TROUBLESHOOTING GUIDE cont...
Page 43: ...43 PARTS DIAGRAM...