40
TROUBLESHOOTING GUIDE (cont)
INFEED / OUTFEED EXTENSION SUPPORT ADJUSTMENT
The infeed and outfeed extension supports are adjustable for coplanar or parallelism if ever
necessary. These are set at the factory. If after planing or edge joining a work piece, an
adjustment is necessary, follow these instructions.
1.
On right hand side of jointer, place a straight edge on the infeed table alone across the
infeed extension support and check for parallelism.
2.
The straight edge should lay flat on the infeed table and the infeed extension support
should just touch or leave a very small gap under the straight edge.
3.
If adjustment is needed, loosen the extension lock nut (G) by hand, pull extension out
about 5 inches, and retighten lock nut (G) Then, with the supplied wrench, loosen screws
(A) and loosen set screws (B) in top of extension end bar. After completing the above,
rotate the rod collars (C) to adjust the height of the end bar. Once correct height has been
achieved, tighten the screws (A and B). Then recheck the parallelism. SEE FIG B
FIG B
Do the same way for the infeed table on the right side of jointer. These adjustments, if necessary,
may take a few attempts.
Summary of Contents for 50180CC-WHD
Page 13: ...13...
Page 34: ...34 TROUBLESHOOTING GUIDE cont...
Page 35: ...35 TROUBLESHOOTING GUIDE cont...
Page 43: ...43 PARTS DIAGRAM...