13
ASSEMBLY
WARNING!
MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE
POWER SOURCE.
ATTACHING DEPTH ADJUSTMENT CRANK HANDLE
Attach the raise/lower adjustment handle to the shaft located on top of the planer and fasten in
place with 1 Hex Socket Head screw M5*25, Tighten screw using supplied hex wrench
ATTACHING DUST PORT
1.
Facing the rear of the machine, place the outfeed table in the down position.
2.
Attach the dust on the cutterhead assembly using 4 of the plastic star knob screws making
sure the 4” port is facing at an upward angle.
NOTE: When operating the planer, we recommend using full size dust collector with a 4” hose, or
a good sized shop vacuum with a cyclone type collection device installed between the planer and
the shop vac using the 2 1 / 2” supplied adapter.
