TECHNICAL DESCRIPTION
There are two WaiWela Mini tank models, a 2.5 gallon model and a 4.0
gallon model. The pressure vessel (water tank) is welded, glass lined
steel and is equipped with an anode rod.
The water heater is equipped with a thermostat and a high limit
temperature switch. A temperature/pressure relief valve is supplied with
the unit.
INSTALLATION INSTRUCTIONS
WM-2.5/WM-4.0
The installation must be completed by a licensed professional. All state
and local codes must be adhered to. The manufacturer will not be liable
for any damages because of failure to comply with these installation
instructions or because of improper installation performed by an
unqualified installer.
CHOOSE A LOCATION
that allows ease of access for maintenance or
servicing, ideally installed at least 8” to 9” from the ceiling (inside top of
cabinet) or any adjacent walls.
WALL MOUNTING
Fasten the supplied mounting bracket to the wall. Use screws that are
suitable for the wall material and the weight of the water heater filled to
capacity (WM-2.5 =41 pounds and WM-4.0 = 57 pounds). Hang the
water heater on the bracket and pull downwards on the water heater
to insure that both “fingers” of the bracket are seated in the mounting
slots. Confirm your water piping orientation (hot and cold) before wall
mounting.
ONLY INSTALL IN VERTICAL POSITION
.
Heater can sit on the floor. Confirm water piping orientation before
finalizing on floor.
ONLY INSTALL IN VERTICAL POSITION!
Models WM-2.5 and WM-4.0 can be installed under the sink.
Page 6
