1
Safe lock
1.1. General notes
1.1.1. Closed position
= Move to the "OPEN" position. (Turn in the direction of the arrow to open
the safe).
1.1.2. Opening the lock
First turn the opening rotary handle to the closed position. This relieves the load
on the lock bolt.
The factory code is C-0-1-2-3-4-5-6
Procedure
1. The lock is in "sleep position" and must first be activated by pressing key C
(approx. 2 seconds)
2. Enter the correct opening code (for initial start-up C0 1 2 3 4 5 6), the green
LED flashes 1 time and the high-low signal tone sounds
3. If the opening rotary handle is not turned clockwise to the open position within
10 seconds, the lock is secured again
4. Turn the opening rotary handle clockwise to the open position and pull the
door open - If the door or the bolt mechanism remains open for longer than 10
seconds, the lock beeps 10 times to indicate that it is in a pretension position
5. Each keystroke is acknowledged with a "beep", pauses longer than 5 seconds
delete the previous entry; or if an incorrect code entry is made, the entry can
be deleted with the "C" key.
6. If an incorrect entry is made, the red LED lights up and a high-pitched signal
tone sounds 12 times. After 3 incorrect entries, the lock is blocked for approx.
12 secondsEach
further incorrect entry extends the blocking time by an additional 12
secondsDuring the blocking
time, the red LED flashes every 5 seconds. The end of the locking period is
indicated
by the green LED lighting up and a low-high signal tone.
7. After the expiration of any lockout time, the correct code must be entered and
the lock can be opened
