1
Safe lock
1.1. General notes
The lock works with a 6-digit numerical code. Each keystroke is confirmed with a
signal consisting of a tone and a flashing sign.
After entering a valid code, a double signal follows. After an invalid entry, a long
beep.
In case of pauses - longer than 10 sec. - the previous entries are deleted, and you
have to start again.
1.1.1. Closed position
= Move to the "OPEN" position. (Turn in the direction of the arrow to open
the safe).
1.1.2. Opening the lock
First turn the opening rotary handle to the closed position. This relieves the load
on the lock bolt.
The factory code is 0-0-1-2-3-4-5-6
Procedure
1. Enter the code - the green LED flashes 1 time and the high-low signal tone
sounds.
2. If the opening rotary handle is not turned clockwise to the open position within
20 seconds, the lock is secured again.
3. Turn the opening rotary handle clockwise to the open position and pull the
door open. If the door or the bolt mechanism remains open for longer than 20
seconds, the lock is in a pretension position.
4. Each keystroke is acknowledged with a "beep", pauses longer than 5 seconds
delete the previous entry; or if an incorrect code entry is made, the entry can
be deleted with the "C" key.
5. If an incorrect entry is made, the green and then the red LED will light up and
4 beeps will sound. After 4 incorrect entries, the lock is blocked for 5 minutes.
After a further two incorrect entries, the locking period starts again. After any
locking time has elapsed, the correct code must be entered, and the lock can
be opened.
