2
1.1.4. Manipulation lock
After 4 invalid code entries, the keypad is blocked for approx. 5 minutes. During
this locking period, a flashing signal is audible every 10 seconds. If 2 incorrect
codes are entered again after the blocking time has elapsed, the blocking time of 5
minutes starts again.
1.1.5. Changing the code "With door open!"
Example
Press "0" key for a long time
0 (
red LED lights up, double signal)
enter the valid code
123456
(double signal)
enter the new code
(example) 122133
(double signal)
confirm the new code
(example) 122133
(double signal)
The new code is stored in the lock. If errors occur during the changeover or if there
is a pause - longer than 10 seconds - the old code remains valid.
The changeover process must be started again.
1.1.6. Safety note
•
Always change the factory code immediately.
•
Do not use personal data such as birthdays, etc. as code.
•
Keep the code (if necessary) in a safe place.
1.1.7. Meaning Acoustic signals
1x Signal:
Accepted2x
Signal:
Code is correct Long
beep:
Code is incorrect
