500.0027-A
4
Subject to technical changes
Reprogramming codes
NOTE:
A new code must always be programmed with the door open, and it must be
tested!
It is a mandatory requirement to reprogramme the
master code (1 2 3 4 5 6)
and the
user
code (1 1 1 1)
, because they could be known to a third party!
What the acoustic and LED signals mean
1x signal with red LED:
Input accepted
3x signal with green LED:
Code is correct
Long signal with red LED:
Code is incorrect / input took too long
Green LED is lit continuously:
Code change can be performed
Procedure for the master code:
1.
Open the door with the current user code (section 3.1.).
2.
Leave the rotary opening handle in the "open" position.
3.
On the input unit, press the "2" key for 3 seconds until a double acoustic signal sounds
and the red LED lights up twice. Then release the "2" key, and the green LED should
be lit continuously.
4.
Enter the current master code (triple acoustic signal with red LED).
5.
Enter the new master code (triple acoustic signal with red LED).
6.
Enter the new master code again to confirm it (triple acoustic signal with red LED).
7.
The green LED goes out to show that the new master code has been programmed.
8.
With the
door open
, press any numeric key and turn the rotary opening handle
counterclockwise into the "closed" position (lock closes automatically).
9.
Press the "8" key until a double acoustic signal sounds and the red LED lights up
twice. The green LED should be lit continuously after this.
10.
Enter the new master code and turn the rotary opening handle clockwise.
11.
If the test opening of the lock was successful, the new code has been programmed
and the safe interior can be closed (section 3.2.).
Procedure for the user code:
1.
Open the door with the current user code (section 3.1.).
2.
Leave the rotary opening handle in the "open" position.
3.
On the input unit, press the "0" key for 3 seconds until a double acoustic signal sounds
and the red LED lights up twice. Then release the "0" key, and the green LED should
be lit continuously.
4.
Press the "1" key once; a triple acoustic signal will sound with the red LED; the green
LED should still be lit.
5.
Enter the current user code (triple acoustic signal with red LED).
6.
Enter the new user code (triple acoustic signal with red LED).
7.
Enter the new user code again to confirm it (triple acoustic signal with red LED).
