20
Connecting
ENG
3. Connecting
3.1 Connecting the luminaire to the
power supply (SELV version)
NOTICE
Material damage caused by wrong
mains voltage.
Damage or destruction of the luminaire.
X
The connection must be conducted
by a trained electrician only.
X
Operate the luminaire at safety
extra low voltage (SELV) only.
X
USA and Canada:
This device
must be connected to a power
supply unit of class 2.
NOTICE
Material damage caused by using
unsuitable cables.
Damage or destruction of the luminaire.
X
Use a flexible cable.
X
Use connecting cable with strands
which have a conductor cross-
section of at least 0.5 mm². For
through-wiring minimum 1.5 mm².
Using unsuitable cables may result in
the loss of tightness of the luminaire.
X
Please observe the allowed cable
diameter of the cable gland.
X
Run cable in such a way that it is
introduced straight into the cable
gland.
X
Make sure that the connecting cable
outside the luminaire remains tight.
NOTICE
Material damage caused by an elec-
trostatically charged person
If the luminaire is opened and connected
by an electrostatically charged person,
the luminaire may become damaged.
X
Make sure that the person is
grounded prior to opening and con-
necting the luminaire.
Fig. 2: Opening the side part A.
X
Unscrew the three screws on the con-
nection side by about 3 to 4 turns, see
X
Take off the side part.
A
B
C
Fig. 3: Luminaire RL70.
NOTE:
To guarantee the tightness of
the luminaire, cables conforming to
the clamping range mentioned must be
X
Remove a maximum of 50 mm of
sheath from the cable
C
.
