20
GB
Instructions For Use Machine Light MCAYL 3 S
„SPOT LED 003“
Description
According to standard DIN EN 1837, an illuminance of 500 lx is required in the work area of machines.
This is often impossible to achieve using a light that is not in the immediate proximity of the tool. However, only
in rare cases is it possible to attach a light directly to the tool slide, since the restricted room available in the
interior of the machine room does not allow this.
In the ideal case, a well illuminated machining area is achieved by combining 2 or more lights:
a) Light for basic illumination of the machining area (using, for example, a Waldmann protective tube light)
b) Additionally mounted light for the immediate machining area (e.g. Waldmann machine light MCXFL 3, MCTFL
3 or MCBFL 3).
The mounted light
MCAYL 3
meets the requirements of the standard if the position of the light does not have
to be changed. Mounting such a light, in addition to the basic illumination already in place, offers a maximum
degree of illumination comfort at the machine.
The use of light emitting diodes (LED) instead of halogen lights allows a significantly higher useful life to be
achieved. This results in fewer machine downtimes as a result of maintenance work.
A housing made of anodised aluminium and a protective borosilicate glass pane are resistant to hot and sharp-
edged chips. The housing is water-proof and resistant to coolants and lubricants.
The selection between several variants of different radiation characteristics makes for universal use.
SPOT LED 003
