Waldorf GP8600E, Installation And Operation Manual

10 

Assembly 

All Models 

All models come pre-assembled. 

NOTE:  This appliance is fitted with adjustable feet to enable the unit to be positioned securely and 

level.  This should be carried out on completion of the electrical connection.  Refer to 
'Electrical Connection' section. 

Optional Accessories (Refer to Replacement Parts List) 

• 

Plinth Kit.  For installation details, refer to the instructions supplied with each kit. 

Electrical Connection 

NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY A QUALIFIED  

PERSON. 

Each appliance should be connected to an adequately protected power supply and isolation switch mounted 
adjacent to, but not behind the appliance.  This switch must be clearly marked and readily accessible in 

case of fire. 

1. 

Check that the electricity supply is correct as shown on the Rating Plate.  (Refer to the dimension 

drawings for rating plate location). 

2. 

The supply terminal connections are located at the rear of the the appliance.  Refer to ‘Electrical 

Connections’ in the ‘Specifications’ section of the manual. 

3. 

Remove the control panel to allow connection access for the electrical supply. 

4. 

Bring the supply cable up through the grommet at the back of the appliance and through the  

compression type gland provided on the rear of the main electrical switchgear panel. 

5. 

Connect the mains supply to L1, L2 and L3 fuse carrier connections for 3 phase and L1 for single 
phase (GP8600E). 

6. 

Connect neutral and earth conductors to neutral stud and earth stud respectively. 

7. 

For all connections ensure that conductors are secure and appropriately terminated. 

8. 

Tighten the cable gland to secure against tension on the cable. 

NOTE: 

• 

This appliance must be grounded / earthed. 

• 

Fixed wiring installations must incorporate an all-pole disconnection switch. 

9. 

Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs 

so that the appliance is level and at the correct height. 

10.  Connect the power supply to the appliance. 
11.  Check that the electrical supply is as shown in 'Specifications' section of this manual. 

Installation

C

AUTION

: 

• 

This appliance is for professional use and is to be used by suitably  
qualified / trained persons only. 

• 

Only qualified service persons are to carry out installation and servicing of 
this appliance.

WARNING: 

T

HIS

APPLIANCE

MUST

BE

EARTHED

.  I

F

THE

SUPPLY

CORD

IS

DAMAGED

, 

IT

MUST

BE

REPLACED

BY

A

SUITABLY

QUALIFIED

PERSON

IN

ORDER

TO

AVOID

A

HAZARD

.