15
Operation
Re-Setting Overtemp Device (All UK and Optional Non-UK Models).
This griddle is fitted
with an overtemp device which isolates gas supply to burners should gas control
system or thermostat malfunction, thus preventing griddle overheating. If pilot fails to ignite after several
attempts, check the overtemp to ensure that it has not tripped.
1.
To reset overtemp, remove gas control
knobs from front of griddle. These are
a push fit onto spindle of gas valves.
2.
Slacken 2 screws securing front control
panel and carefully remove control
panel, ensuring that leads to piezo
igniter are disconnected from rear of
piezo buttons.
3.
Using a small screwdriver, depress
centre of overtemp reset button.
4.
Re-connect piezo igniter leads to rear
of piezo igniter buttons.
5.
Refit front control panel onto griddle and
secure in position with the 2 securing screws.
6.
Refit gas control knobs to gas spindles.
7.
Attempt to re-light pilot burners as shown above. Should pilot burners still not ignite, call a qualified
service person to investigate problem.
For Refrigeration Cabinet Operation refer to Refrigeration Cabinet Installation and Operation
Manual supplied with appliance.
Overtemp fitted to
Gas Control Valve.
O v e r t e m p
reset button
Fig 4
IMPORTANT:
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, appliance requires
IMMEDIATE service by a qualified service person and should not be used until such service is
carried out.
Summary of Contents for GP8600G
Page 27: ......
