5
Installation Requirements
NOTE:
It is most important that this appliance is installed correctly and that operation is correct
before use. Installation shall comply with local electrical and health and safety
requirements.
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.
Waldorf Electric Griddle Ranges Electric Static / Convection Oven are designed to provide years of
satisfactory service and correct installation is essential to achieve the best performance, efficiency and
trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical, fire and health and safety.
Australia / New Zealand
AS / NZS3000
- Wiring Rules.
United Kingdom:
BS 7671
- Requirements for Electrical Installations.
Installations must be carried out by authorised persons only. Failure to install equipment to
the relevant codes and manufacturer’s specifications shown in this section will void the
warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only
to be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.
Unpacking
Remove all packaging and transit protection from the appliance including all protective plastic
coating from the exterior stainless steel panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
Ensure that the adjustable feet / castors are securely fitted.
Report any deficiencies to the distributor who supplied the appliance.
Check that the available electrical supply is correct to that shown on the rating plate (Refer to the
dimension drawings for rating plate location).
Location
1.
Installation must include adequate clearance and ventilation, to prevent dangerous build up of
combustion products.
2.
Never directly connect a ventilation system to the appliance flue outlet.
3.
Position the appliance in its approximate working position.
4.
The legs / castors must always be fitted to the base of the appliance.
5. Components
having
adjustments
protected (e.g. paint sealed) by the manufacturer are only to be
adjusted by an authorised service agent. They are not to be adjusted by the installation person.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to
the appliance flue outlet.
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Installation
Combustible Surface Non Combustible Surface
Left / Right Hand Side
250 mm
0 mm
Rear
50 mm
0 mm
