Waldorf GP8910GE, Installation And Operation Manual

14 

Operation

Turning 'Off' the Griddle Main Burner / Pilot 

1. 

Turn the gas control knob clockwise to the pilot position.  The main burner will extinguish and the 

pilot burner will remain alight. 

2. 

To turn 'OFF' the appliance completely, turn the gas control knob fully clockwise to the 'O' position, 

the pilot burner will extinguish. 

Oven 

The oven is fitted with top and bottom elements.  The thermostat maintains the overall oven  
temperature.  The top element is further controlled by the oven top heat control.  Convection Ovens 

(GP8910GEC / GP8121GEC) are fitted with a circulation fan. 

NOTE:  The Thermostat on the oven provides overall control of the temperature within the oven by 

controlling both elements, where as the Oven Top Heat Control provides a means of 
balancing the distribution of heat between the top and bottom of the oven. 

Place oven racks in desired position. 

Preheat: 

Preheat the oven by selecting the desired temperature, and turning the oven top heat control (Refer 

to Fig 5 on page 12) to a maximum of 2.  When the desired temperature is reached, the amber neon 

will go out. 

Cooking: 

When the desired temperature has been reached, load the oven with product and set the oven top 

heat control to the desired setting. 

NOTE: When the oven top heat control is set to a high setting, proportionally more heat is 

produced at the top of the oven.  (This can be used for browning, etc, during the cooking 
operation).  With the oven top heat control set on a low setting, less heat is produced from 
the top oven elements.  (This mode is used for general baking purposes to prevent cakes, 
etc, from getting too brown and crisp on the top, but  allow the cake to cook through). 

To obtain more top heat during cooking, turn the oven top heat control to a higher position.  (The 

higher the setting, the more top heat). 

Turning ‘OFF’ the Oven: 

a.  Turn the oven top heat control to the ‘O’ off position.  The top heating will be turned ‘OFF’ and 

the upper heating indicator lamp (Amber) will extinguish. 

b.  Turn the thermostat control knob to the ‘O’ off position and the lower heating indicator lamp 

(Amber) will extinguish.  The oven is now turned ‘OFF’. 

! IMPORTANT 

DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s). 
NEVER block or cover the openings on each side of the sole plate(s). 

! IMPORTANT 

DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s). 
NEVER block or cover the openings on each side of the sole plate(s). 

Should any abnormal operation like; 
    - ignition problems, 
    - abnormal burner flame, 
    - burner control problems, 
    - partial or full loss of burner flame in normal operation, be noticed, the appliance requires 

IMMEDIATE service by a qualified service person and should not be used until such service is 
carried out. 

IMPORTANT