Setup and Connections
10
Iridium Keyboard Quickstart
7.
Press the
Power
switch on the rear panel of your
Iridium Keyboard.
8.
Then switch on your computer (if connected), the
mixing console and finally the amplifier or active
monitor speakers.
r
The startup procedure is about 10-15 seconds. After
this, the Iridium Keyboard is ready to play.
r
The overall volume of the Iridium Keyboard can be
controlled with the
Master Volume
dial. This also
affects the
Headphones
output.
r
If you do not choose to connect a mixing console,
you can patch the Iridium Keyboard’s output signals
directly to an amplifier or an audio interface. Use an
input usually called Line, Aux or Tape input.
r
The Iridium Keyboard’s audio outputs deliver unba-
lanced line levels. When connecting to an amplifier,
a mixing console or an audio interface with automa-
tic balanced/unbalanced sensing inputs, please
make sure to use TS mono jack cables and not TRS
stereo jack cables.
s
Before connecting and disconnecting the Iridium
Keyboard to a power supply source, turn your
amp’s volume control all the way down to avoid
damage due to on/off switching noise. The Iridi-
um Keyboard produces a line level output signal.
Please take care that the connected playback de-
vice is suitable for the line level of an electronic
instrument. Never use the microphone or phono
input of the connected amp!
Summary of Contents for IRIDIUM
Page 1: ...Quickstart Für deutsche Version bitte umdrehen ...
Page 2: ......